PIR switch for led strips. Perfect solution for walk-in closets, hallways and entrys where lights are normally swiched ON/OFF quite fast. Turns lights on when detects motion closer than 2m away. You can adjust the time the lights are on between 6-70 seconds (after last detected movement).
Is suitable to be used with strips with voltage: 12-24V.
With 12V led strips, maximum 96W load and with 24V led strips maximum 192W load (8A), but we recommend you to calculate 10% extra so that it won't run on full power all the time (12V max. would be 87W and 24V would be 174,5W).
Solder between the strip and the driver (12-24V input and 12-24V output).
1. Make sure you use constant voltage driver instead of constant current driver. Have the power off when soldering.
2. Make sure the positive "+" and the negative "-" are correctly connected to led power supply (led driver). Positive and negative cannot be reversed!
3. PIR sensor is installed trough the diffuser, so you need to drill a 10,5mm hole on the diffuser.
Install PIR switch on a led strip inside the profile and solder the switch and the strip next to each other! See video.