Details
High quality 24V CCT led strip!
This led strip uses two led cirquits which enables the change in colour temperature between 2500-6500K (everything from warm yellowish white to cold, bluish white). The CRI around 90, and it shows colours naturally (when in 4000K, the colours are not "tinted" to yellow or blue). The led strip is dimmable with ie. TRIAC driver. As a tape, it uses 3M tape that is extra durable and attatches the strip firmly. Led strip 14,4W/m is equivalent to 120cm fluorocent tube, so you'll even save energy!
Lighting
The strip can be controlled with VaLO -series rotatable dimmer (RGB/CCT) and receiver (RGB/CCT). To product can be seen at our warehouse store.
This strip is mostly used in indirect lighting and for creating different moods. CCT led strip has 60 led circuits on a meter. This makes the light even, if installed in a way you cannot see the light source ie. indirect light. When installed on a profile, there are visible dots to be seen if looked straight to the light (not visible when installed next to a wall, so tat the strip is not visible).
Installation
LED strip comes in a 5m roll that can be cut to measure in every 5cm. We recommend that you solder the wanted lengths together as we have noticed that the fast clips tend to loosen after few years and then the light starts flickering.
If you have more than 10m of strip, you need to feed the power from both ends or from the centre to minimize the powerloss. All installations should be made on top of aluminium (ie. aluminium profile), that way the excess heat gets conducted away from led circuit and makes it last longer.
LED strip works in boats, as it is 24VDC you might not even need a driver!
Remember to order a driver (unless it is for a boat, car or with solar power of 24VDC).
Dimming
LedStores CCT strip can be dimmed and adjusted with wireless VaLO -series controller and receiver (RGB/CCT). This is a perfect solution also in places where you have power for the strip but no wall swich ready. With this system, you just hook the wireless receiver between led strip and driver and have the remote were ever you like.
Create a light of your own
Why would you use led strip only in traditional way (cabinets, indirect light etc.) when you can make a light of almost anything. Old cart wheel, zink bucket or even a wooden boat turns in to a light when you put led strip inside it! Get creative!
For the CCT ability to work, you need a wireless button and a receiver.
LED strip comes in a 5m roll that can be cut to measure in every 5cm. We recommend that you solder the wanted lengths together as we have noticed that the fast clips tend to loosen after few years and then the light starts flickering.
If you have more than 10m of strip, you need to feed the power from both ends or from the centre to minimize the powerloss. All installations should be made on top of aluminium (ie. aluminium profile), that way the excess heat gets conducted away from led circuit and makes it last longer.
LED strip works in boats, as it is 24VDC you might not even need a driver!
Remember to order a driver (unless it is for a boat, car or with solar power of 24VDC).